Skip to content

Gas Leak Detection The Hill

Gas leak detection in The Hill means finding the joint or pipe that is letting gas out, fixing it and proving the line tight before anything is relit. Your plumber in The Hill quotes the repair as a fixed figure, and the rest of our gas fitting work is on the hub.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Gas fitter at work on a kitchen oven

What Gives a Gas Leak Away?

Know these signs before a small escape turns into a big one:

  • A sulphur or rotten-egg smell near a stove, heater, meter or pipe run
  • A soft hiss at a fitting you only notice late at night
  • Flames on the cooktop or heater burning yellow or orange, not blue
  • A gas bill higher than last quarter's with no new appliance

Any one of those is reason enough to ring.

Gas cooktop burner alight
Plumber beside a newly installed continuous-flow gas hot water unit

If Your Nose Says Gas, Act First

Turn off burners, leave the building with everyone, and touch no switches. Once outside, ring the gas emergency number on your bill, since the network shuts down leaks at the meter or street. With the supply safe, call us on (02) 4063 1093 for the repair.

How the Detection Job Runs

  1. 01

    Shut off

    We close the meter valve first, so no gas flows while the line is opened.

  2. 02

    Sniff out

    An electronic gas detector is run along each joint, and a pipe locator maps any buried section.

  3. 03

    Remake

    The failed joint or length is renewed, and its neighbours on the run are checked too.

  4. 04

    Prove it

    The run holds test pressure, each burner is relit, and the results go to you on paper.

What Moves a Gas Leak Job's Price?

On a leak, the figure rests on:

  • How far the search goes, from a single fitting at the meter to a pipe buried under a paved courtyard
  • The pipe's material, because aged copper or old galvanised can need replacing past the leak itself
  • Getting to the pipe, which is slow work inside stone or double-brick walls
  • Night or weekend attendance at the after-hours rate

Terraces, Conversions and Their Gas Lines

Flats built into old buildings

Census figures put 61.3 per cent of dwellings here in flats or apartments, and some are conversions of older buildings that kept the pipe already in the walls. A meter bank, a common riser or a line buried in a party wall takes longer to search than an exposed pipe in a modern build.

Sea spray on exposed pipe

Salt carried up off the Tasman eats at bare steel fittings outside. If your meter or a balcony barbecue point faces the ocean, we look over the neighbouring joints for rust while the gas is off.

A new cooktop for the repaired line is booked through gas appliance installation, and a water leak goes to water leak detection.

When We're Not the Right Call

Gas escaping from the meter itself or the street pipe is for the gas network's emergency crew. A spark igniter that has died because the power outlet or wiring failed calls for an electrician.

Gas Leak Questions From The Hill

Do you find gas leaks in apartment buildings?

Yes. Where a converted building or newer block feeds several flats from one meter bank or riser, we work out whether the escape is inside one unit or on the common pipe, shut that part down and repair it. Owners and tenants get the same written report.

Can you test the gas lines in an old terrace before I renovate the kitchen?

Yes, and the time to do it is while the walls are still closed. We put the old pipe under test pressure, look at each joint and confirm whether it can feed the new cooktop or oven. Any length that needs renewing is priced before your builder starts.

Is a gas leak always an emergency?

Treat a heavy smell inside, an audible hiss or burners misbehaving as urgent. Clear the house, leave switches off and ring the gas emergency number. A whiff you only catch now and then still needs testing, and we are Available 24/7.

Do you repair the pipework once the leak is found?

Yes. Once the detector has found the escape, the faulty length is remade, the full run goes back under test pressure and each connected burner is relit. That repair carries our 365-day warranty on all work.

Need a plumber? Call or send the form

Call (02) 4063 1093 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1093

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1093 Get a quote